Skip to product information
1 of 2

String Swing Mic Stand Mount Stage Guitar Hanger

String Swing Mic Stand Mount Stage Guitar Hanger

Regular price $13.99 USD
Regular price Sale price $13.99 USD
Sale Sold out

Inventory varies by location. Please give us a call to check stock in your preferred location!

Winter Haven: (863) 294-4216
Lakeland: (863) 686-3179

SKU: SS-CC04

View full details

Details


These guitar hangers are made of American steel and powdercoated for a durable finish. Ideal for holding your guitar while performing on stage or in your music studio. Safely hang your guitar on your microphone stand, amp, or suitcase during the performance. Works well with round bottom and tripod stands and fits the top or bottom half of most stands. Attaches to any 1” diameter pipe.
  • Heavy duty, low profile hanger
  • Works best with acoustic, electric and bass guitars
  • Made in the USA
  • Backed with a structural lifetime warranty
  • Keeper rings included with Mic Stand (Classical Guitar)
  • Mounting hardware included

String Swing Hangers have a wide variety of uses in all areas of music. This unit is designed to mount onto the side of a rack cabinet or amp speaker cabinet. The late is almost flush on the surface and the yoke, or neck cradle, is screwed onto the plate for use on stage. The yoke stores well in your guitar case after the performance is over. 

PLEASE USE CAUTION WHEN CHOOSING A LOCATION TO INSTALL THIS UNIT TO YOUR AMP. 
Be certain there are no electrical components in the area you are mounting the unit.


Installation Instructions:
The recommended weight limit for use of the drywall toggles is 10 lbs. of under. Anything heavier should be mounted to a stud or a board attached to studs. 

DO NOT REUSE TOGGLES FOR REMOUNTING OR PUTTING A NEW SCREW IN A SECOND TIME

Chose location for hanger. Drive screws through mounting holes of hanger into wall using phillips screwdriver. If a wall stud is not found these pilot holes are necessary for installing the plastic toggles. To do this use the screwdriver to push and turn the toggle clockwise until flush. Remount hanger with screws into wall toggles.

Roll Keeper Rings onto the ends of yoke arms. All yokes may be adjusted to fit any size mandolin or guitar. To adjust the yoke width, look at the area at the first fret of the instrument. Adjust yoke so the instrument will freely pass through the opening, then rest it behind the Keeper Rings. To widen, grasp each arm of the yoke and pull apart. To narrow, put hand around yoke arms and squeeze. 

Due to either the nature of use or shipping costs we are unable to accept returns on this product if it is shipped. If you have any questions or concerns on if this is the right product for you, don't hesistate to reach out to us!

For local customers we may accept exchanges for store credit for unopened/unused products.

Our full return policy can be found at the link below.