The DigiTech FreqOut Natural Feedback Creator allows you to get sweet, natural feedback at any volume, with or without distortion. The FreqOut is perfect for situations where volume must be controlled like in the studio, with in ear monitors, or low-volume performance and practice. However, the FreqOut can also be used at gig volume to focus out-of-control feedback on a preferred harmonic at any stage position. The FreqOut uses a 9VDC power supply to easily integrate into your existing pedalboard.
MOMENTARY SWITCH
Sets the operation of the Footswitch. When set to the "ON" position, the feedback effect will only be enabled as long as the Footswitch is held down. When set to the "OFF" position, the feedback effect will toggle between enabled and bypassed modes each time the Footswitch is pressed.
DRY SWITCH
Turns the dry signal path on or off when the feedback effect is enabled.
GAIN KNOB & ONSET KNOB
Gain knob controls the amount of feedback signal that is mixed in with teh dry guitar signal. Onset knob sets the time it takes for the feedback to begin after an input note is detected.
TYPE KNOB
Select from one of seven feedback harmonic types.
FEEDBACK LEDS
These LEDs light from the center LED out as the feedback signal increases. The rate of feedback is controlled by the Onset knob.
GENERAL SPECIFICATIONS
- Controls: Feedback, Momentary On/Off, Dry On/Off, Gain, Onset, Type, Effect On/Off
- Signal to Noise Ratio: > -106dB (A weighted); ref = max level, 22 kHz bandwidth
- THD: 0.004% @ 1 kHz; ref = 1 dBu w/ unity gain
- A/D/A Conversion: 24-bit
- Outut Type: 1/4” Unbalanced TS (Tip-Sleeve)
- Max Output Level: +10 dBu
- Output Impedance: 1 kΩ (Effect enabled or effect bypassed w/ Momentary switch on) ; True Bypass (Effect bypassed w/ Momentary switch off)
- Input Type: 1/4” Unbalanced TS (Tip-Sleeve)
- Max Input Level: +5 dBu
- Input Impedance: 1 MΩ (Effect enabled or effect bypassed w/ Momentary switch on) ; True Bypass (Effect bypassed w/ Momentary switch off)
- Power Consumption: 2.1 Watts (235 mA typical @ 9 VDC)
- Power Requirements: 9 VDC External Adapter (sold separately)
- Power Adapter (Sold Separately): PS0913DC-04 (US, JA, EU, AU, UK)
- Power Adapter Output: 9 VDC 1.3 A
- Dimensions: 4.75" (120mm) L x 1.75" (44mm) H x 2.875" (73mm) W
- Weight: 0.8lb (363g)